Xbee - Mesh with Xbee

Xbee - Mesh with Xbee

Xbee mesh Using three Xbee modules



The Mesh network is a network of high-performance as
Data can be sent to the target in more ways, it can transfer data
to a destination. Despite the loss of any part of the system (depending on system
design, the user's)system is a system that has been very popular.



From the image across we have used the two stylesXBee of together
1) Coordinator.
2) Routers



XBee set to work as a Coordinator.

1) into the Modem Configuration.
2) Select Modem XBee according to the models used.
3) Change Firmware to ZIGBEE END DEVICE AT
(with models XBee XB24-ZB) or ZNET 2.5 ROUTER / END DEVICE AT (with models XBee XB24-B).
4) set the PAN (Personal Area Network) can be set as the user is assigned. But here I will set up a 100.
5) the Destination (destination you want. Transfer data) by setting.
DH = 00.
DL = FFFF.
6) Select the check mark to Always Update Firmware and then click Write.
*XBee defined as the Coordinator will not work in standby mode. Save energy.

XBee set to run as a Router.

1) into the Modem Configuration.
2) Select Modem XBee according to the models used.
3) Change Firmware to ZIGBEE ROUTER AT (with models XBee XB24-ZB) or ZNET 2.5 ROUTER / END DEVICE AT (with models XBee XB24-B).
4) set the PAN (Personal Area Network) will be set up as Coordinator.
5) the Destination (destination you want. Transmission), and Node name by setting the following.
DH = 00.
DL = 00.
NI = Node name as desired.

the next step is to sort out some program with the arduinos to demo this !!!!any ideas ??